https://www.high-endrolex.com/10

eKonferencije.com: DETERMINATION OF STRESS AND TORSION ANGLE OF THE CARDAN SHAFT FOR KNOWN LOAD

DETERMINATION OF STRESS AND TORSION ANGLE OF THE CARDAN SHAFT FOR KNOWN LOAD

1. Miroslav Milutinović, University of East Sarajevo, Faculty for Mechanical Engineering East Sarajevo, Republic of Srpska, Bosnia and Herzegovina
2. Sposoje Trifković, University of East Sarajevo, Faculty for Mechanical Engineering East Sarajevo, Republic of Srpska, Bosnia and Herzegovina

In the course of the exploitation of freight vehicles there is a change of load and variations in working conditions. If the cardan shaft holds a certain time interval maximum load It can be considered that it will not come to its disadvantage at lower loads. In this paper are given the maximum voltage values on the shaft as well as the shaft tapping angles for the known load. Based on the obtained results, the diagrams are formed, which show the tendency of the stress development and curvature, for the results obtained. For the same load was performed numerical analysis of stress state on the cardan shaft cross.

Кључне речи :

Тематска област: Mechanics and Design

Датум: 25.04.2017.

13th International Conference on Accomplishments in Mechanical and Industrial Engineering

Датотека уз рад  (8.33 MB)


Остали радови са конференције


Претражи радове

https://www.high-endrolex.com/10